DIY Mic Pre Kits, Lunchbox Mic Preamp Kits, Power Supply Kits

I have your PSU-4448 with toroidal transformer. I'm wondering how I should wire this up. I found a couple of diagrams on your forum with some searching but there are two things I'm wondering: Where do the "CT" -- red and orange, I think -- wires go on the PM1000, (if anywhere), and how should I wire up the LED? There's no LED pad on the PSU-4448 like on the SC-1. Any info would be appreciated!

Thanks!
Chris

OH! I just saw the updated instructions for the 4448. I'd still like to see how the LED should be wired, (and it indicates that the orange wire goes to AC2 - I think it should say the yellow wire).

Thanks again!
Chris

http://www.fivefish.net/diy/psu4448/pdf/psu4448docs.pdf

Orange and Red are tied together.
Black connected to AC1.
Yellow connected to AC2.

For the LED, you'd need to put a series limiting resistor. Compute R = E/I

E=44V
I = 5mA = .005A
R = 8.8K I'd even use 10K or higher.
Wattage = (ExE) / R
= (44 x 44) / 10000
= .19 Watts = You can use a 1/4 watt resistor, or 1/2 Watt.

_________________

That's perfect, Owel. Thanks so much!

Chris