DIY Mic Pre Kits, Lunchbox Mic Preamp Kits, Power Supply Kits

First off I have to say I really enjoyed putting the PSU together, incredibly well designed. I can't wait to fire it up However I want to hook it up and I am a bit confused and I just want to be certain so I don't blow anything up

I know in one document on the forum says to hook up the LED to LED2 on the PSU PCB...does that still apply with the new 4.2 revision and if so should I just remove the LED that I already put in that place and solder in the wires to the front panel mount LED?

Ruel was kind enough to send the answer hopefully this can help others with the same question

"Brian,

You can wire it in parallel with one of the LED lamps on the PSU board.... or instead of soldering an LED lamp on the PSU board, just wire it to the front panel LED.

Any of them will do....

Or,

connect them to the V+ and GND terminal of the PSU, but make sure to use a resistor... like 6K8 or higher.


Ruel"

Thanks again Ruel