DIY Mic Pre Kits, Lunchbox Mic Preamp Kits, Power Supply Kits

DIY Forum
It is currently Sun May 19, 2013 8:43 am

View unanswered posts | View active topics


Board index » FiveFish Studios Forum » SC-1mk3 Mic Preamp

All times are UTC - 5 hours




Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
owel
 Post subject: How to wire Neutrik Combo XLR/TRS jacks
PostPosted: Mon Jul 23, 2007 4:16 pm 
Offline

Joined: Mon Jun 25, 2007 6:09 pm
Posts: 1261
Location: Music City
Pin 1, 2, 3 on the XLR jack goes to pad 1, 2, 3 on PCB.

Also, short the following connections on the jacks.

Pin 1 = Sleeve = Ground
Pin 2= Tip = Hot
Pin 3 = Ring = Cold

_________________
Image
Top
 Profile  
 
shaaregeulah
 Post subject:
PostPosted: Sun Aug 26, 2007 11:34 am 
Offline

Joined: Mon Jun 25, 2007 7:17 pm
Posts: 180
Location: Brooklyn, NY
Would a diagram be possible?

I finally finished all 3 pcb's and am ready to wire it all up.
Top
 Profile  
 
owel
 Post subject:
PostPosted: Sun Aug 26, 2007 1:25 pm 
Offline

Joined: Mon Jun 25, 2007 6:09 pm
Posts: 1261
Location: Music City
The diagram will depend on what particular Neutrik/XLR combo jack model # you're using. There's several variations... the jack should have some markings or embossing on the plastic. Or use a Multitester if you want to be sure.

Then just follow the guide above.

_________________
Image
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » FiveFish Studios Forum » SC-1mk3 Mic Preamp

All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group